4 min read

Guide

Knitting Gauge: How to Knit and Measure a Gauge Swatch (and Why It Matters)

Short answer

Gauge is the number of stitches and rows in 10 cm of knitting. To measure it, knit a square of at least 15 × 15 cm with the pattern's yarn and needles, wash and dry it the way you'll treat the finished piece, and count the stitches across the middle 10 cm. More stitches than the pattern? Go up a needle size. Fewer? Go down.

Why gauge matters

With chunky yarn, a single stitch makes a big difference to the size. For example: a 108 cm sweater at a gauge of 6 stitches to 10 cm takes 65 stitches. If you get 7 stitches to 10 cm, those 65 stitches measure only 93 cm: 15 cm smaller than planned. A swatch also shows whether you like the fabric: neither stiff nor too loose.

How to knit a gauge swatch, step by step

  1. Use the same yarn and needles you'll use for the project, and the stitch the pattern gives (usually stockinette).
  2. Cast on enough stitches for a swatch at least 15 cm wide: the pattern gauge × 1.5, plus 4 edge stitches. With FACES at 6 stitches to 10 cm, about 13 stitches.
  3. Knit at least 15 cm high. If the pattern is knitted in the round, swatch in the round too: gauge changes.
  4. Bind off loosely, wash and dry flat, exactly as you'll treat the garment. Wool relaxes when wet and the measurement changes. See how to wash and block chunky wool.
  5. Measure in the middle, away from the edges, with a rigid ruler. Count the stitches across 10 cm and the rows over 10 cm, including half stitches.

What to do if your swatch doesn't match

Your swatchMeansWhat to do
More stitches per 10 cm than the patternYou knit tightly: the garment will come out smallerBigger needles (0.5–1 mm; with super bulky yarn, up to 2–3 mm)
Fewer stitches per 10 cm than the patternYou knit loosely: the garment will come out biggerSmaller needles
Stitches match, rows don'tCommon for many knittersIf the pattern gives lengths in cm, it's fine: knit to the measurement

Change your needle size, not the way you knit: it's far more reliable.

Gauge of our yarns

YarnNeedlesStitchGauge in 10 cm
FACES (200 g / 100 m)15 mmStockinette6–6.5 sts × 9–10 rows
FACES12 mmGarter stitch8.5 sts × 12 rows
FACES10 mm2×2 rib8 sts × 13 rows
BeMe (100 g / 120 m)8 mmStockinette12 sts × 16 rows
NOVA (50 g / 150 m)12 mmStockinette6 sts × 11 rows
CROCHET CRUSH (raffia)3.5 mm hookSingle crochet16 sts × 18 rows

These are the gauges from our patterns; yours may be half a stitch either way. To switch to another yarn, see how to substitute yarn in a pattern.

Tips for chunky yarn

  • Measure the whole swatch and divide. At 6 stitches to 10 cm, half a stitch is almost 1 cm: measure the full width of, say, 12 stitches and work it out.
  • Count the Vs, not the gaps. In stockinette, each "V" is one stitch.
  • Don't stretch the swatch while measuring. Lay it on the table without pressing it flat.

FAQ

Do I really need a gauge swatch?
For hats and scarves you can skip it. For sweaters and fitted pieces, yes: it's the only way to get the size right.

How big should a gauge swatch be?
At least 15 × 15 cm, so you can measure 10 cm in the middle without the edges.

Do I have to wash it?
Yes. Wool changes size when washed; if you measure it unwashed, the garment may change later.

Which matters more, stitches or rows?
Stitches: they decide the width. Rows can be adjusted by knitting to the length in cm.

The Journal in your inbox

New lessons, as soon as they’re out